When you install a set of BBK Performance long tube exhaust headers on your muscle car or truck, the O2 sensor locations are relocated on the BBK header and mid pipe. The factory O2 sensor wire connectors will not be long enough to connect to the sensors any longer.. These extension harnesses extend the length needed and allow them to now connect easily - All our extension harnesses feature OEM Factory connectors to allow simple plug in installation to the factory wire harness so that the relocation is super simple and does not require any splicing of the factory harness at all. (Sold in Pairs)
Features and Benefits
- Made In The USA
- OEM connectors and heat protective sleeves make installation a snap. Simply transfer your factory oxygen sensors to the new location in the collector and click these into place on the OEM harness.
Product Details
- Generic Primary
- Generic Primary
- Generic Primary
- Primary
- Primary
- Primary
- Primary
- Primary
- Primary
- Primary
- Primary
- Primary
- Generic Primary
Part Number: bbk1121
Description: O2 Sensor Wire Extension Harness
WARNING CA Proposition 65: Yes
WARNING CA Proposition 65 Message: WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects; or other reproductive harm (For a list of chemicals and more information go to www.p65warnings.ca.gov)
Title: BBK O2 Harness Extension
Prop 65 - Short Label: BBK Performance www.P65Warnings.ca.website_2100x759.jpg
Prop 65 (C, R or CR): CR
Prop 65 Yes/No: Yes
Length: 16
Universal Or Specific Fit: Specific
Wire Quantity: 2
Connector Gender: 1x male 1x female on each wire
Connector Style: OEM Style Direct Fit
Fitment: Front Or Rear / Up stream or Down stream
Fits: 2018-2024 Ford Mustang (see fitment details).
