Steeda ProFlow Cold Air Intake for the 2024-2026 Mustang GT andDark Horse
Open up the Gen 4 Coyote’s dual-intake system with Steeda’s ProFlow cold air intake. Large billet mass-air housings, smooth silicone tubes and reusable filters reduce restriction while maintaining clean MAF signal quality and factory-style drivability—without requiring a tune.
Performance Features
- No tune required for installation
- Steeda-tested gains of up to 13 peak horsepower and 11 lb-ft of torque on the factory calibration
- Over 4.25-inch-ID CNC-machined 6061 billet-aluminum mass-air housings
- Custom four-ply silicone tubes begin at 4.75 inches and taper to 95 mm to increase air velocity
- Reusable high-flow oiled air filters
- Retains the factory airbox lids for a sealed ram-air configuration
- Can also be operated with the lids removed for an open-intake appearance and sound
- CNC-machined billet PCV fittings and stainless-steel hose clamps
- Made in the USA with a limited lifetime warranty
Fitment and Notes
- Fits 2024-2026 Ford Mustang GT 5.0L
- Fits 2024-2026 Ford Mustang Dark Horse 5.0L
- Approximate installation time: one hour with basic hand tools
- Steeda part number: 555-3234
Emissions Notice: This product is not approved for sale in California or other jurisdictions requiring a California Executive Order number. It is intended for off-road use where permitted. The vehicle owner is responsible for legal compliance.
California Proposition 65 Warning: Cancer and reproductive harm — www.P65Warnings.ca.gov.
